Linear drain Wiper 800 mm Invisible

73000

Waterproofing kit is used to seal shower tray as well as connections between walls and floor. It is recommended for concrete and mandatory for timber flooring. Each kit contains: 4kg tanking liquid, 1l primer, 10m sealing tape, 2 corners, 2 pipe collars. One kit covers 3 m² with 2 coats.

Complete Magnum Underfloor heating set, including mat, advanced thermostat, floor sensor and fitting instructions. Fully suitable with our other products. Appropriate thermostat allows to set desired temperature of the floor.

Magnum Underfloor heating mats are available in several sizes. Mats can be shaped but the heating cable cannot be cut, therefore it is advised to buy smaller than required heated area. Stationary elements like bath or furniture should be excluded from calculations. The cables are fully earth sheathed.

Delivery:Free | 1-3 working days
Payment:Card | Over the phone | PayPal | BACS
Returns:30 days return right
Support:020 7193 0953 • 017 0927 3601

£ 186.39

tax incl.

£ 232.99 tax incl. -20%

Trade discount policy:bulk orders and returning customers

Save for later

Send to a friend

Send product information

Basic product info and a link to a product will be sent to a person specified above.

Where should we reply to?

We will do our best to reply as fast as possible.

Floor level drain Wiper Invisible 800 mm is stainless steel shower gully without vertical frame, which gives it flexibility to be installed under any finish material. It is most commonly used to be in vinyl, marble, stone, exotic wood or glass floorings. Entire drain including the grating should be covered with your finish material so only channels for water to flow are visible after installation. It comes with insulating flange and sealing membrane which allow to achieve 100% waterproof seal.

Wet room drains Invisible have included grate 80 mm wide and total width with flange is 140 mm. Cover is 794 mm long and drain 860 mm long in total. It should be covered entirely with floor finish material, best if it's edges could be properly adapted to leave sufficient amount of space for gaps for water to flow. Fabric for cleaning purposes before sticking finish material to cover is included.

Suitable siphon trap which can take up to 26 l/min, with water seal of 20 mm, manufactured by McAlpine is always added to the drain. It provides enough capacity for a standard shower head and seal prevents smells from getting back. It can be easily connected to any waste system as it comes with pipe which can be rotated and adjusted. Even after installation is completed it can be cleaned from above making usage as easy as installation.

If you buy this product you will receive (parts included):

Channel length800 mm
Grate styleInvisible
Channel height20 mm
Total height88 mm
Channel width80 mm
Total width140 mm
Material304 S 15 grade stainless steel
AdditionalsTanking kit, Adjustable legs
Drain surfacebrush
Waste trapPlastic (PCV)
Steel collarIntegrated
CleaningFrom above (Easy clean system)
ModelInvisible
Set consistsLinear drain body · stainless steel collar · sealing membrane · drain grating · siphon trap
  • Length (X): 800 [mm],
  • Height of channel (C): 20 [mm],
  • Height to the centre of waste pipe (G): 58 [mm] (can be adjusted),
  • Total height (H): 88 [mm],
  • Width of internal tray (B): 70 [mm],
  • Width of channel (Y): 80 [mm],
  • Width of insulating flange (F): 140 [mm] (included)
  • Width of Sealing Membrane (S): 250 [mm] (included)
  • Flange to top edge of channel (T): 15 [mm]
  • Complete siphon, pipe diameter: 1.5" (British standard size),
  • Pipe height adjustable and rotatable at 360°,
  • Drain's cover included.

Product is suitable for:
Timber floor Concrete floor
Vinyl
Hardened glass
Gres
Granit
Marble
Exotic wood
Tiles
Mosaic

Linear shower drain advantages

The ISOL-ONE sealing mat is made from a polyethylene film coated with a special non-woven fabric on both sides, so that it bonds with the glue layer. Its installation is recommended in all areas that require sealing. The mat is resistant to the cracking of the substrate, ensures the seal up of the entire surface, reduces installation time, allowing to lay the tiles immediately after gluing the mat.


Sealing membrane

Adjustable feet are two small metal parts that can be connected to each channel end. They allow you to precisely set the unit height and level. Thanks to the red caps you can anchor the drain to the floor. They are part of unit, included in price and always added to each drain.

Adjustable legs

The tanking kit is a ready-mixed, under-tile tanking system to protect water sensitive substrates from exposure to water. Suitable for wet areas such as bathrooms, showers in residential buildings, hotels, old people's homes and hospitals. Should not be used in places exposed to pressurised water, for an instance swimming pools. Ready to use, no mixing required and easy to apply with a roller. The kit includes a high performance joint reinforcing tape to protect against movement in floor joins and corners etc. The contents are all INSIDE the bucket and the contents are protected in the bucket with polystyrene infill's to stop transit damage.The instructions are printed on the rear of the tanking kit.

For anti-moisture insulation systems in wet rooms and rooms intended for human residence. The tanking liquid is a ready-to-use singlecomponent, solvent-free sealant composed of polymer dispersion, fillers and modifying additives. When applied to the surface, upon binding it creates a flexible and water-insulating layer.

Tanking kit contains:

  • 4kg Tanking Liquid
  • 1l Primer
  • 10 Metres flexible Sealing Tape
  • 2 Flexible Pipe Collars
  • 2 Corners

Features:

  • Consumption to 1,2kg/m²
  • Solvent free
  • Drying time: 2h

Tanking liquid

Tanking liquidThe tanking liquid is a ready to use, single component, solvent-free sealant mass, consisting of polymer dispersion, fillers and additives. When applied to a substrate and cured, it forms a flexible waterproofing coating. The product is intended for use inside places intended for human residence, especially in humid areas (such as bathrooms, kitchens, laundries), to perform insulation against moisture under linings and coverings, such as ceramic tiles, glazed tiles, terracotta, wooden floors and panels, and synthetic carpets.

Primer

Tanking primerThe product is intended for priming absorbent and porous surfaces, inside and outside buildings. It is especially recommended for cement - limestone plaster, gas concrete, plaster-carton boards and cement plaster. The primer has a high penetration ability, is deeply absorbed into the substrate, thus strengthening it, while allowing for „breathing”. These benefits improve the structure of the substrates, which, due to the passage of time, have lost their appropriate parameters. The priming solution improves adhesion to the surface of other materials that will be used on the primed substrate. By reducing the absorbency of the substrate, the wear of the applied coating materials, emulsion paints, glues, mineral putties reduces as well. The solution, due to the content of the biocide and fungicide, protects the primed substrate against the formation of mold and bacteria in the product.

10m sealing tape · 2x flexible pipe collars · 2x corners

Tanking mattPipe collarCorner

Complete Underfloor Heating Kit

It is possible to include a complete Underfloor Heating Kit to your order. All you need to do is to choose the required size. Additional package, with heating mat, appropriate thermostat, sensor and instructions will be dispatched together with the other goods.

To calculate required mat size you need to get square coverage of the floor and exclude any permanent / fixed fixtures from them. It is also recommended to buy slightly smaller mat than calculated size - you can shape it but cannot cut the cables, therefore too large mat could not be installed.

MAGNUM Underfloor Heating

The MAGNUM Electric Heating Mat is a unique type of floor heating mat. The system has been designed to be used on an existing tiled floor or an existing finished floor, so that floor heating can still be installed there. The mat is approximately 4 mm thick and can be included in a layer of adhesive without any demolishing or grinding. The mat fits virtually underneath the surface. This decreases the heating time of the floor, that also makes this system suitable for rooms that are not permanently occupied including bathrooms, studies, playrooms, etc.

Heating mat

Underfloor heating mat set consists of all necessary parts for installation. One Thermostat is needed for every 23 m² of heating mat. It is included as optional, to allow ordering mat for custom areas, for example if you need 13 m² of mat total, you should buy 10 m² with one of the thermostats set as include and 3 m² with thermostat not included. In case you require less mat coverage than possible to buy from our product pictures, for example 14.5 m² you should always round low with your purchase and buy 14 m² as the mat is impossible to cut. It can be shaped but not shortened to size.


Underfloor heating mat technical properties:

  • EMC-free 2-conductor cable fitted to fibre-optic net
  • 2.5 meter 3-core supply cable
  • Fully encased in an aluminium earthed sheath
  • Unique blind connection between the heating and the connection cable
  • Chrome/Nickel resistance wire
  • PTFE (Teflon) insulation
  • PVC protective sheath
  • 10 -11 watt per meter resistance wire, 230 Volt
  • Cable diameter approximately 4 mm
  • Mat widths of 25 or 50 cm
  • Complies with current NEN standards for installation in completely wet rooms

Underfloor Heating Mat

Thermostat

In some situations the digital regulation is not required and so the preference is for a simple on/off operation. Specifically industrial applications where the heating must remain on at all times. Therefore MAGNUM has designed the Standard Control: a simple on/off thermostat with temperature regulation that is clearly easy to operate.

Specification:

  • Voltage: 230 Volt - 50/60 Hz
  • Maximum load: 16A / 230 V
  • Temperature range: +5 to +40°C
  • Housing: IP21
  • Color: Polar white (RAL 9010)
  • Testing: CE
  • Technical details:
  • On/off thermostat complete with temperature regulation
  • Including floor sensor
  • Integral room sensor and floor limit sensor
  • Multi frame adapter system for: Gira, Jung, Elko, Merten, Busch Jager, etc.
Underfloor Heating Thermostat

We supply McAlpine CD-HC26-65 PCV (polypropylen) waste trap with our drains. To clean them you can simply dismantle it from above when installed, and waterflow will remove any dirt. If not you can use chemicals. 

The waste trap provides Water Seal that prevents any bad smells to get back to your shower.

  • Colour: white,
  • Total height: 61,50 mm,
  • Waste pipe diameter: 1.5" (british standard size)
  • Water seal: 20mm
  • Flow rate [l/min]: 26/50 (for a 15mm/120mm liquid column)
  • Ready to be connected to waste system
  • Additional info: Waste Grid and Dip Tube removable from top to facilitate easy cleaning. All McAlpine Shower Traps with top access surpass the minimum required flow rate of 24 litres per minute when tested in accordance with clause 5 of BS EN 274-2:2002

Caution. Please read the instructions carefully before installation.


  • The diagram shows various parts of the channel and their dimensions can be found on the More info tab.
  • We recommend that you do not remove the protective foil from the grating until the installation is complete
  • The instructions refer to the correct installation of the channel only and do not include information regarding insulation or other elements of the shower cabin such as sealing connections between the shower walls and floor as well as water proofing.
  • The channel should be installed together with the siphon trap and then the adjustable legs should be glued in the places shown.

Documents available below are available to everybody for free to download. They can be open in high quality on your computer and be printed for further use.

Wiper Invisible installation Wiper Invisible technical drawingSiphon technical drawing  Long term guarantee

Opinions, reviews and tests for:
Linear drain Wiper 800 mm Invisible
Average grade: 3
Ratings number: 1
100% Customers recommend this product.
5
0%
4
0%
3
100%
2
0%
1
0%
Do you own this product?
Leave product review to help other customers to make the right choice

Customer product reviews
Rated 3.00 on the scale 1 - 5 based on 1 customer reviews

it's wider

It is actually wider than it looks in the pictures

Was this comment useful to you? Yes No
Question will be displayed after moderation.

Typical questions asked about products:
How long is the delivery?
Is the product easy to fit?
Which options should I choose?