Shower Waterproofing Tanking kit Wiper
Warning: Last items in stock!
The tanking kit is used in rooms exposed to moisture, in order to water-insulate the surfaces on which ceramic plates will be laid. It is recommended in spaces requiring high-level waterproof protection due to increased moisture (e.g. in showers, bathrooms, toilets, laundries, kitchens etc.). Water insulation may be used on any type of surface: gypsum-board walls, plastered walls, walls made of gas-concrete blocks, wood-based materials, old ceramic facings, old stone facings, etc.
The tanking kit is a ready-mixed, under-tile tanking system to protect water sensitive substrates from exposure to water. Suitable for wet areas not exposed to pressurised water, such as bathrooms, showers in residential buildings, hotels, old people's homes and hospitals. Ready to use, no mixing required and easy to apply with a roller. The kit includes a high performance joint reinforcing tape to protect against movement in floor joins and corners etc. The contents are all INSIDE the bucket and the contents are protected in the bucket with polystyrene infill's to stop transit damage. The instructions are printed on the rear of the tanking kit.
For anti-moisture insulation systems in wet rooms and rooms intended for human residence. The tanking liquid is a ready-to-use single component, solvent-free sealant composed of polymer dispersion, fillers and modifying additives. When applied to the surface, upon binding it creates a flexible and water-insulating layer.
The tanking liquid is a ready to use, single component, solvent-free sealant mass, consisting of polymer dispersion, fillers and additives. When applied to a substrate and cured, it forms a flexible waterproofing coating. The product is intended for use inside places intended for human residence, especially in humid areas (such as bathrooms, kitchens, laundries), to perform insulation against moisture under linings and coverings, such as ceramic tiles, glazed tiles, terracotta, wooden floors and panels, and synthetic carpets.
The product is intended for priming absorbent and porous surfaces, inside and outside buildings. It is especially recommended for cement - limestone plaster, gas concrete, plaster-carton boards and cement plaster. The primer has a high penetration ability, is deeply absorbed into the substrate, thus strengthening it, while allowing for „breathing”. These benefits improve the structure of the substrates, which, due to the passage of time, have lost their appropriate parameters. The priming solution improves adhesion to the surface of other materials that will be used on the primed substrate. By reducing the absorbency of the substrate, the wear of the applied coating materials, emulsion paints, glues, mineral putties reduces as well. The solution, due to the content of the biocide and fungicide, protects the primed substrate against the formation of mold and bacteria in the product.
We have the wiper tanking kit and have the instructions for the liquid and primer but nothing that says how the sealing tape/membrane is applied to this layer ? Ie: do we need to let it tac or does it go straight onto the tanking liquid ?Any advise ? Many thanks Regards Tracey
Sealing membrane should be applied after applying first layer of tanking liquid. It works as a great adhesive to stick sealing membrane. If the first layer is already dry, you can use tile adhesive which also works well.
Everything should be covered with another tanking liquid layer afterwards.
David M 020 7193 0953